Rainwater Outlet Installation Guide

Step-by-step guide on installing a rainwater outlet into your next EPDM project.

You can download this guide as a PDF here

	Step 1 Place rainwater outlet through the pre-cut hole and mark around it using a crayon or similar. Shop EPDM Drain Outlets
	Step 2 Apply primer the underside of the rainwater outlet and 1cm beyond the marked area on the rubber using a quick scrubber pad and handle. Allow both surfaces to dry.
	Step 3 Mate the surfaces together and compress with silicone roller.
	Step 4 Round the corners of the 12” flashing tape (Rainwater flashing kit) with scissors and neatly position over outlet. Mark the perimeter with crayon.
	Step 5 Apply primer to the rubber and outlet using the scrubber pad and handle and extend primer beyond the crayon line by 2cm.
	Step 6 Once touch dry, neatly position the 12" flashing tape and carefully remove the backing paper. Roller firmly in place and use a sharp blade to carefully cut out the hole.